B-Flex® BF Mylar is a polyester film designed to be used as a transfer media for printable heat transfer vinyl.
Once the protective layer has been removed, BF Mylar needs to be applied to the printed film. Avoid creating air bubbles during this process.
Listing is for 1 x 30cm x 35cm piece
How to use:
Cut a piece of mask slightly wider than the image to cover.
Remove the paper backing from the mask and set it aside.
Adhesive side up, place the mask down on a smooth, firm surface.
With the image facing down, centre it over the mask letting the middle drop down onto the adhesive, followed by the rest of the image.
Place your squeegee at a 45° angle over the centre of the image. Using firm pressure, push the squeegee towards the outer edge of the image.
This removes any trapped air creating a bond between the image and the mask.
Repeat this process in several directions.
Lift a corner of the mask, use a steady motion to separate the mask from the image.
Place the transferred image back on the shiny side of the original masking paper you had set aside.